Stabilizovatelé uložení předních ramen

JAY PARTS STABILIZER BUSHING & SLEEVES KIT CAN AM REAR

The sleeves are made of hardened stainless steel, only the best is good enough for our claim!
PE-GL with added oil is used as a self-lubricating, wear-resistant material for the bushings. Sealing against dirt and water takes over an O-ring.

FEATURES
- Made in Europe
- hardened stainless steel sleeves
- stainless
- bushings with helical groove inside
- PE-GL bushings with oil additive
- sealed with O-rings

DELIVERY PER KIT
4 sleeves
8 bushings (pre-assembled with O-rings)
8 washers
One kit is for both sides (left and right)!

ATTENTION
Do not hit the bushings with a hammer!
Put enough grease in the bushings before installation.
As a result, when greasing, apply grease only until resistance is first detected in the grease gun. Fat must not spill out!

RECOMMENDATION
Always swap both sides, as there is a big difference in quality compared to the original spare parts!
We reccomend using water resistant grease when installing, BEL RAY Waterproof you can find in our shop.